Oddworld Logo Necklace Questions

acedude · #1 08-02-2016, 12:09 PM

I have had an urge for a long time to make a necklace based off the OWI logo. All the ones I see online look poorly built and made of clay. I want to drag a 3D printer into this. I am posting a few questions just to see what you guys think.

Do you see the OWI logo's gem as transparent, or opaque?

Do you see the OW gem egg shaped, or a flattened disk?

Do you think the gem is held by 2 prongs, one from each side, or only one in the front? (see image http://i.imgur.com/0jB4iwf.jpg)

Fuzzle Guy · #2 08-02-2016, 12:43 PM

I'ma hazard a guess and say it's a wooden carving, almost flat but raised to add definition.

***Xavier*** · #3 08-03-2016, 02:44 AM

Sherry has an Oddworld Logo pin, maybe you can base your design on it.

You can see it in this video:

http://oddworldlibrary.net/archives/...76/category/68

Paul · #4 08-03-2016, 04:18 AM

Do you see the OWI logo's gem as transparent, or opaque?
transparent - maybe with glow stick-a-like juice floating in it or LEDs or something.

Do you see the OW gem egg shaped, or a flattened disk?
egg but I guess disk is more practical.

Do you think the gem is held by 2 prongs, one from each side, or only one in the front?
Probably just the front.. but again is that practical, would that hold?

Fuzzle Guy · #5 08-17-2016, 01:01 PM

:

Sherry has an Oddworld Logo pin, maybe you can base your design on it.

You can see it in this video:

http://oddworldlibrary.net/archives/...76/category/68

You'd be lucky to see anything in that video.

Gunnr · #6 08-29-2016, 11:16 PM

I agree that the idea of two prongs would help in holding the gem in place. Or maybe if the gem is stuck to a sort of plaque from the back and held by a single prong up front? Though the back might compromise the look you are going for.
I always thought of the gem being either spherical or raised in front and flat on the back like a dew drop