Oddworld Logo Necklace Questions
I have had an urge for a long time to make a necklace based off the OWI logo. All the ones I see online look poorly built and made of clay. I want to drag a 3D printer into this. I am posting a few questions just to see what you guys think.
Do you see the OWI logo's gem as transparent, or opaque? Do you see the OW gem egg shaped, or a flattened disk? Do you think the gem is held by 2 prongs, one from each side, or only one in the front? (see image http://i.imgur.com/0jB4iwf.jpg) |
https://s-media-cache-ak0.pinimg.com...932b2fab47.jpg
I'ma hazard a guess and say it's a wooden carving, almost flat but raised to add definition. |
Sherry has an Oddworld Logo pin, maybe you can base your design on it.
You can see it in this video: http://oddworldlibrary.net/archives/...76/category/68 |
Do you see the OWI logo's gem as transparent, or opaque?
transparent - maybe with glow stick-a-like juice floating in it or LEDs or something. Do you see the OW gem egg shaped, or a flattened disk? egg but I guess disk is more practical. Do you think the gem is held by 2 prongs, one from each side, or only one in the front? Probably just the front.. but again is that practical, would that hold? |
:
|
I agree that the idea of two prongs would help in holding the gem in place. Or maybe if the gem is stuck to a sort of plaque from the back and held by a single prong up front? Though the back might compromise the look you are going for.
I always thought of the gem being either spherical or raised in front and flat on the back like a dew drop |